USING THE SAW
ATTENTION
!
Maximum depth of cut at 0° is 2
1
⁄
8
"
[54mm].
ATTENTION
!
When the workpiece is less than 4
"
[102mm]
wide, support the guide track with scrap pieces of the same thickness
as the workpiece.
ATTENTION
!
When interrupting a cut, continue to hold the saw in
the plunge position, release the switch, and wait for the saw blade to come to
a complete stop. Release downward pressure to retract the blade. To resume,
with the power off, plunge the saw to cutting depth to ensure the blade is
centered in the saw kerf. Release downward pressure to retract the blade.
Depress the switch, plunge the saw to cutting depth, and continue the cut.
WARNING:
!
Always hold the saw with both hands when cutting.
Keep one hand on the switch handle and the other on the forward grip.
WARNING:
!
This saw is intended for cutting wood and wood
products only. Do not cut metal, masonry, glass, masonry-type planking,
cement board, tile or plastic with this saw.
WARNING:
!
Do not tie, tape, or otherwise lock the switch in the
on position. Hold by hand only
WARNING:
!
The saw is equipped with a riving knife that
automatically extends with the blade. This is an important part of the anti-
kickback protection. Periodically check to make sure it operates freely. If
you have any concerns about the operation of the riving knife, do not use
the saw and contact Kreg Customer Service.
Straight Cuts
(
1
) Set cut depth to
1
⁄
8
" [3mm] more than
workpiece thickness.
(
2
) Set the blade mode selector to Cut,
adjust the tracking controllers and
engage the anti-kickback control.
(
3
) Align the guide track anti-chip strip with
your cut marks. The workpiece must be
under the guide track with the waste
piece to the outside.
(
4
) Position the saw on the guide track,
press the switch interlock and depress
switch. Plunge the saw to cutting depth
and push the saw forward. At end of cut,
release downward pressure and return
the saw to full-up position. Allow the
blade to stop before lifting the saw from
the guide track.
4
2
3
3
1
1
2
1
2
Riving Knife
ATTENTION
!
The Kreg plunge saw has a bevel range of -1° to
47° with stops at 0° and 45°. Maximum depth of cut at 45° is 1
1
⁄
2
"
[38mm].
Bevel Cuts
(
1
) Loosen the bevel locks.
(
2
) Tilt the saw and align the bevel indicator
with the desired angle on the bevel scale.
(
3
) Tighten the bevel locks.
Содержание ADAPTIVE CUTTING SYSTEM
Страница 79: ...NOTES REMARQUES NOTAS ...
