Kranzle therm 1165-1, Руководство по эксплуатации

Страница: 20 / 31

38 39
Applying additives
1. Switch off the high-pressure cleaner
2. Cut off the water supply
3. Open the safety trigger gun catch briefly until the pressure is released
4. Apply safety catch on the trigger gun
5. Remove high-pressure hose and safety trigger gun
6. Emptying high-pressure pump: Hold high-pressure hose and switch
motor on until water jet stops escaping at the outlet.
7. Pull the plug from the socket
8. Clean high-pressure hose and wind up without loops, fix hose drum
9. Clean and wind up the power supply cable
10. Clean the water inlet sieve
11. Apply locking brake
12. Store high-pressure cleaners in frost-free rooms in winter
Taking out of operation
Frost protection
For protecting the high-pressure cleaner against frost please empty it completely.
Separate high-pressure cleaner from water supply and switch it on. By opening
the safety trigger gun the high-pressure pump presses water out of the water
tank. However, do not allow the high-pressure cleaner to operate without
water for more than one minute. Fill the anti-freeze agent into the water box
and turn on the high-pressure cleaner. Wait with opened gun until the agent
spurts out of the nozzle.
Suction of additives
Due to the water tank fitted to the therm-1-series it is now possible to directly
suck the detergent into the high-pressure pump thus reducing output loss
and increasing the efficiency considerably.
1. Place chemicals filter into container
with additives.
2. Dosing of detergent is done by turning
the detergent valve.
3. By closing the detergent valve the
supply of detergent is stopped.
Only open the dosing valve, if the detergent sieve is placed in a liquid!
Sucked air leads to destruction of the pump seals of the high-pressure
cleaner (No warranty)!
The additive must reveal a neutral pH value of 7-9. This machine has been
designed for use of cleaning agents supplied or specifically recommended
by the manufacturer. The use of other cleaning agents or chemicals may
impair the safety of the machine. Observe and comply with relevant
regulations, e.g. directives governing protective equipment, waste-water
regulations, etc.
Attention solvents!
Never suck in liquids containing solvents like varnish solvents, petrol, oil
or similar liquids! Seals inside the high-pressure cleaner are no resistant
against solvents! The spray mist of solvents is highly inflammable,
explosive and poisonous.