Kranzle therm 1165-1, Руководство по эксплуатации

Страница: 17 / 31

32 33
Putting into operation Putting into operation
9. Screw together lance and safety
trigger gun pressure tightly.
8. Lance on to safety trigger gun.
When using high-pressure hose extensions take care that the max.
length of 20 m is not exceeded!
Accessories may only be connected to a Kränzle-approved trigger gun
with safety catch.
Neither set up or operate the therm-1-series in rooms where there
is a risk of fire or explosion nor put it into puddles. Do not use the
high-pressure cleaner under water. If, none the less, the high-pressure
cleaner is operated in a hazardous area, the applicable safety regulations
are to be observed.
6. For high-pressure cleaners with hose
drum, please loosen the fixation and
then completely unwind the high-pres-
sure hose. For high-pressure cleaners
without hose drum the high-pressure
hose included in the scope of the
delivery must be screwed with the
pump outlet in a tight and pressure
tight manner. Unwind high-pressure
hose straight and without nooses.
The high-pressure hose may leave
signs of abrasion on some floors.
Alternatively, please also find
non-marking high-pressure hoses
in our range.
7. Tightly screw together high-pressure
hose and safety trigger gun.
10. Check water inlet filter for cleanliness
prior to putting the high-pressure
cleaner into operation.
Unscrew the filter cup manually, take
out the water inlet screen, flush thor-
oughly and clean with the remaining
parts under clear water. If the screen
is dirty, no water can run through and
no pressure can build up.
Check the water inlet sieve for damage. Do not operate the
high-pressure cleaner without or with a damaged filter.
11. Connect water hose to water inlet
(minimum requirements; 5 m hose length,
cross-section ¾", 10 bar). The high-
pressure cleaner may be connected to
a water mains (1-10 bar pre-pressure)
with either cold or hot water (up to
60 °C). The therm-1-series provides
the opportunity of sucking in water
out of a container (see direct suction).
Be careful when using hot water!
When running your high-pressure cleaner with hot water of 60 °C raised
temperatures occur. Do not touch the metal parts of the high-pressure
cleaner without safety gloves!