Kramer WP-5VH2, Руководство пользователя

Страница: 21 / 101

WP-5VH2 - Operating the WP-5VH2 15
15
7 Operating the WP-5VH2
Powering up the
WP-5VH2
recalls the last settings from the non-volatile memory,
(that is, the configuration of the device when it was powered down).
7.1 Selecting an Input Manually
Any of the following methods can be used to select an input:
 Protocol 3000 command
 Remote contact-closure switch
 Web pages
7.2 Locking the EDID
To prevent the stored EDID (either default or read from a device) from being
overwritten, either send a Protocol 3000 command or use the Web pages.
7.3 Resetting the WP-5VH2
To perform a soft reset of the WP-5VH2
:
 Briefly press the Reset button.
The device resets
To reset the WP-5VH2 to factory default parameters
:
 Press and hold the Reset button for five seconds.
The device is reset to factory default parameters
7.4 Analog Audio Output Volume Control
The analog audio output volume can be controlled using remote, contact-closure
switches connected to pins 3 and 4 of the Remote terminal block, (see
Section 5.1 ). For volume control using the Web pages, see Section 9.1 .
Note
: Not applicable to the
WP-5VH2E
.
The up/down volume steps per press are detailed in the table below.