Kramer VS-1616DN-EM, Руководство пользователя

Страница: 10 / 156

Kramer Electronics Ltd.
VS-1616DN-EM
– Introduction
7
10 DEFAULT SETUP Button Press to recall the default setup (see Recalling the Default
Setup on page 21 ).
11 IR Receiver Infrared remote control sensor (for future use).
12 IR LED Lights yellow when receiving commands from the IR
remote control transmitter (for future use).
13 PS-1 POWER LED Lights green when power supply is active.
14 PS-1 ERROR LED Lights red when an error is detected. Briefly lights red
immediately following a power disruption (e.g., cable
disconnection, power off, and so on).
15 TAKE Button Press to confirm actions (see Confirming a Switching
Action on page 19 ).
16 MENU Button Press once to enable the ALL, OFF, STO and RCL buttons
(see
Using the Configuration Menu on page 23 ).
Press again to enter the configuration menu (see Using the
Config Menu on page 27 ).
When in a Menu, press to cycle through the menu items.
17 LOCK Button Press and hold for approximately 2 sec to lock/unlock the
front panel buttons (see
Locking the Front Panel
Buttons on page 22 ).
18 OUTPUTS/INPUTS
LCD Display
Displays the outputs (upper row) switched to the selected
inputs (lower row), (see
Startup Display on page 17 ).
Displays user interface messages and menus.
19 Front Panel Locking Screws Release the 14 front panel locking screws to open the front
panel and access the fan arrays (see
Replacing a FAN-
16DN Fan Array on page 95 ).
20 Power Supply Thumbscrews Release the 4 power supply thumbscrews to install /
remove the
PS-16DN power supply (see Installing a PS-
16DN Power Supply on page 96 ).
Figure 2: VS-1616DN-EM Front Panel Numeric Keypad
# Feature Function
21
◄ (Backward)
Press to shift the sliding window to the right (the LCD display only shows 13
cross-points out of a total of 16).
22 1, 2, 3, 4, 5, 6, 7, 8,
9, 0
Numeric keypad, 1 to 0.
23
► (Forward)
Press to shift the sliding window to the left (the LCD display only shows 13
cross-points out of a total of 16).