©
KRAMER ELECTRONICS LTD.
Issue 1-16 May 30, 2017
10
2.
Basic Switcher Set-Up
Inspect the shipping box and make sure that no damage was caused
during transportation. If you see any damage, immediately contact
the shipping carrier. Remove the unit, power cord, CD and QSG
from the shipping carton. Inspect the unit and ensure that there is
no damage caused during shipping.
You can install the unit on a clean flat surface or on an equipment rack using the rack-mount ears.
The unit should always be installed in a well ventilated, static free environment and close to the AC
power source. Max. operating temperature is 0
0
C to 40
0
C and 5% to 95% non-condensing
humidity.
Connect the display device (Monitor, Projector, etc.) to one of the output connectors DVI/HDMI
are available on all models, and SDI or HDBaseT are featured only on certain models. If applicable,
connect the speakers or external audio amp to the audio output connectors.
Connect the Input sources (Blu-Ray Player, Set Top Box, PC, etc.). Use connectors from different
groups to achieve the ¼ sec ultra-fast switching. Groups are identified by the button color on the
front panel. If applicable, also connect any audio sources to the 3.5mm stereo jacks.
Inset the power cord to turn-on the unit. The boot-up process takes about one minute.