Kramer VP-725N, Руководство пользователя

Страница: 17 / 62

12 VP-725N - Connecting the VP-725N Presentation Switcher/Scaler
5 Connecting the VP-725N Presentation
Switcher/Scaler
This section describes how to connect the VP-725N . In particular, how to connect
the:
• VP-725N rear panel (see Section 5.1 )
• Interlaced and progressive RGBS and RGsB inputs (see Section 5.2 )
• PC (see Section 5.3 )
• Ethernet port (see Section 5.4 )
Using the VP-725N you can select any one of the 21 inputs and scale that input to
up to three scaled outputs (at the identical resolution).
5.1 Connecting the VP-725N
To connect the VP-725N , connect the following to the rear panel, as the example
in Figure 3 illustrates:
Always switch off the power to each device before connecting it to your
VP-725N . After connecting your VP-725N , connect its power and then
switch on the power to each device.
1. Connect one or more of the following video sources:

Up to four UXGA graphics sources (for example, computers) to the
15-pin HD input connectors
These connectors also accept interlaced and progressive RGBS and RGsB
signals (see Section 5.2 )

Up to four composite video sources (for example, DVD players) to the
BNC input connectors

Up to four s-Video sources to the 4-pin input connectors (not illustrated
in
Figure 3 )

Up to four component video (sometimes called YUV, or Y, B-Y, R-Y, or
Y, Pb/Cb, Pr/Cr) sources or four RGB sources to the four sets of 3
BNC connectors, G/Y, B/Pb, and R/Pr.
For example, an HDTV satellite receiver to COMP IN 1 and an RGB camera
connected to COMP IN 4.
i