16
TP-576 - Operating the TP-576
5.4
Acquiring the EDID
Acquiring the EDID is usually done only once, when the machine is being set up in
an installation. Once acquired, the EDID is saved in non-volatile memory and
further acquisition is not necessary.
Initially, the
TP-576
operates with the factory default EDID. This lets you connect
the power before connecting one of the acceptors or sources.
You can acquire the EDID from:
One output (the local output and the output on the transmitter). The relevant
output illuminates
Two connected outputs, the auto-mix mode (both output LEDs illuminate)
The EDID acquired is a weighted average of all the connected outputs. For example, if
several displays with different resolutions are connected to the outputs, the acquired
EDID supports all the resolutions, as well as other parameters included in the EDID.
The default EDID (both output LEDs flash)
To acquire the EDID, do the following:
1. Connect the power.
2. Connect the output or outputs from which you want to acquire the EDID.
3. Press and hold the EDID SETUP button to select the desired EDID.
The OUT LEDs illuminate in the following cycle: OUT 1, OUT 2, both flash
(default) and both illuminate (auto-mix).
4. Release the button when reaching the desired set up.
The EDID is now acquired.
If you set the machine to acquire the EDID from an output that is not connected, the
Default EDID is acquired.
im Vertrieb von CAMBOARD Electronics
www.camboard.de
Tel. 07131 911201
Fax 07131 911203
