12
TP-410 - Connecting the TP-410
If required, connect the GND pin on the RS-485 port of the PC to the G
(ground) pin on
the rear panel of the
TP-410
For RS-485 communication, the ground is usually not connected between the
devices. When using a shielded cable, the shield may be grounded on one side
2. If this is the only
TP-410
on the RS-485 bus, set the RS-485 termination
DIP-switch (see
Section 7.3
If several units are connected via the RS-485 bus, set the termination switches on both
physical ends of the bus
) to ON (for RS-485 line termination with 120
Ω
).
5.4 Connecting to the TP-410 via the ETHERNET
You can connect the
TP-410
via the Ethernet, using a crossover cable
(see
Section 5.4.1
) for direct connection to the PC or a straight through cable (see
5.4.2
Section
5.4.1 Connecting the ETHERNET Port directly to a PC (Crossover Cable)
) for connection via a network hub or network router.
You can connect the Ethernet port of the
TP-410
to the Ethernet port on your PC,
via a crossover cable with RJ-45 connectors.
This type of connection is recommended for identification of the
factory default IP Address of the
TP-410 during the initial
configuration
.
After connecting the Ethernet port, configure your PC as follows:
1. Right-click the My Network Places icon on your desktop.
2. Select
Properties
.
3. Right-click Local Area Connection Properties.
4. Select
Properties
.
The Local Area Connection Properties window appears.
5. Select the Internet Protocol (TCP/IP) and click the
Properties
Button (see
Figure 5
).
i
Содержание TP-410
Страница 2: ......
Страница 21: ...18 TP 410 Configuration and Distribution of Control Data Figure 11 Connecting Multiple TP 410 Units via RS 485...
Страница 33: ......
Страница 34: ...P N 2 9 0 0 0 0 0 7 3 3 QS Rev 3...