TP-410 - Connecting the TP-410
9
9
5
Connecting the TP-410
This section describes how to connect:
•
The
TP-410
(see
Section 5.1
•
Several
TP-410
units (see
)
Section 5.5
•
To the
TP-410
via RS-232 (see
)
Section 5.2
•
To the
TP-410
via RS-485 (see
)
Section 5.3
•
To the
TP-410
via the Ethernet (see
)
Section 5.4
5.1
Connecting the TP-410
)
Always switch off the power to each device before connecting it to your
TP-410
. After connecting your
TP-410
, connect its power and then
switch on the power to each device.
To connect the
TP-410
, as illustrated in the example in
Figure 3
:
1. Connect a computer graphics source to the UXGA IN 15-pin HD connector.
2. Connect an unbalanced stereo audio source (for example, the audio source
of the computer) to the AUDIO INPUT 3.5mm mini jack connector.
You can also connect a digital audio source to the S/PDIF RCA connector and select
the desired input via the AUDIO INPUT SELECTOR (release the button to select the
analog audio and push to select the S/PDIF audio source)
3. Connect a transmitter (for example, the Kramer
TP-125EDID
or another
TP-410
unit) to the TP-IN CAT 5 connector.
You can connect one or both of the inputs (LOCAL and/or TP).
Press the SOURCE INPUT SELECT button to select LOCAL (UXGA
IN) or release the button to select TP.
4. Connect the OUT 15-pin HD connector to a UXGA accepter (for example, a
local display).
5. Connect the OUT unbalanced stereo audio and/or S/PDIF to unbalanced
audio and/or digital audio acceptors, respectively (not shown in
Figure 3
).
i
i
Содержание TP-410
Страница 2: ......
Страница 21: ...18 TP 410 Configuration and Distribution of Control Data Figure 11 Connecting Multiple TP 410 Units via RS 485...
Страница 33: ......
Страница 34: ...P N 2 9 0 0 0 0 0 7 3 3 QS Rev 3...