8
Yarden 6-ID - Installing the Yarden 6-ID
Figure 3: Yarden 6-ID Cut-out Template
4.3
Installing the Speaker Wires
To install the speaker, do the following:
1. Prepare the wires for the speaker:
Cut the wires to similar lengths
For achieving high quality sound
Measure the length from each speaker to the receiver, and cut the
wires accordingly, adding some access wire length to let you easily
remove the speakers from the bracket without having to disconnect the
input wires
2. Strip the ends of the wires to expose a length of approximately 3/8 inch.
3. Remove the speaker grille by inserting a paper clip into one of the grille
openings and pulling it.
4. Adjust appropriate tap setting (see
Figure 4
).
Set the tap according to the power requirements of the speaker based on its location in the
room (for example, a speaker located in a remote corner may require additional power)
