18
SP-1G - Using the SP-1G Menus
•
Press ENTER to save the setting temporarily (until powered down)
•
Save the new position settings using the Saving Setups procedure (see
Section 6.2
)
6.6
Setting the Genlock
Use this menu to set genlock parameters; activation, source and timing.
To set the genlock:
•
Press MENU to enter the menu mode
•
Press
▼
or
▲
until
SET1. GENLOCK (enter submenu)
is displayed
•
Press ENTER go into the submenu
•
Press
▼
and
▲
to navigate through the submenu
6.6.1
Resetting the Genlock
To reset the genlock:
•
From
SET1 GENLOCK FACTORY RESET
, press ENTER to reset the
genlock to its factory settings
•
Save the new genlock using the procedure Saving Setups in
Section 6.2
6.6.2
Activating/Deactivating the Genlock
When the genlock is turned OFF, an internal crystal generator is used as the
reference source.
To activate or deactivate the genlock:
•
Press
▼ or ▲ until
SET1 GenlckState
•
Press
◄ or ►
to choose the settings:
OFF(FreeRun)
or
ON
•
Press ENTER to save the setting temporarily (until powered down)
6.6.3
Setting the Genlock Reference Source
Use the genlock reference source to select either a dedicated genlock input or any
one of the four SDI inputs.
Содержание SP-1G
