10
WARNING:
Failure to position
the parts in accordance with these
diagrams may result in property
damage or personal injury.
CAUTION:
After installation and
periodically thereafter, check to en-
sure that no flame comes in
contact with any log. With the heater
set to HIGH, check to see if flames
contact any log. If so, reposition logs
according to the log installation
instructions in this manual. Flames
contacting logs will create soot.
INSTALLING LOGS
Figure 10 -Installing Log Set (Top
View)
INSTALLATION
Continued
IMPORTANT
:
Make sure log does
not cover any burner ports (see Fig-
ure 10).
OPERATING HEATER
n
FOR YOUR SAFETY
n
READ BEFORE
LIGHTING
WARNING:
If you do not
follow these instructions exactly, a fire
or explosion may result causing prop-
erty d am age, p erso n al in j ury o r
loss of life.
A. This appliance has a pilot which
must be lighted by control system,
W hen lighting the pilot, follow
t h e s e in s t r u c tio n s e xac t ly.
B . BE FO RE LIGH TING sm ell all
around the appliance area for
gas. Be sure to smell next to the
floor because some gas is
heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
SEE WARNING in Page 1 for proper
instructions.
C. Use only your hand to push in control
knob. Never use tools. If the appliance
could not operate , don't try to repair it,
Call a qualified service technician or gas
supplier. Forced or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part
has been under water. Immediately call
a qualified service technician to inspect
the appliance and to replace any part of
the control system and any gas control
which has been under water.
TO TURN OFF GAS TO APPLIANCE
Shut off heater
1. Press the IGN/OFF button. (See fig 12)
2. Set the Switch on OFF location. (See fig
11)
Shutting off burner only( pilot stay lit)
1.Press the BURNER to set flame OFF se-
lect
Fig 12 - Front of the Transmitter
NOTICE:
During initial operation
of new
fireplace
, burning logs will
give off a paper-burning smell. Or-
ange flame will also be present.
Open a window to vent smell. This
will only last a few hours.
CAUTION:
Do not try to adjust
heating levels by using the equipment
shutoff valve.
LIGHTING INSTRUCTIONS
1. STOP! Read the safety information,
page 3.
2. Make sure equipment shutoff
valve is fully open.
Figure 11 - Manual ON/OFF Button
and ON/OFF Switch Location
If your remote transmitter is lost or
does not function, you can press the
Manual ON/OFF
Button in order to
manually operate your heater.
Function of Manual ON/OFF Button
and Power ON/OFF Switch
Note:
To operate your heater the ON/
OF F sw itch mu st b e in th e ON
position. The RED light indicates
there is electrical power to your heater
when the ON/OFF switch is in the ON
position. The GREEN light indicates
the pilot light is ON .
Note:
Please wait for one minute to
light again after shutting off heater.
Note: If operating by transmitter, you
must set the control knob on
ELECTRIC position. Do not set the
control knob between the locked
position, otherwise there will be no
power to the heater