13
GLASS FRAME
MANTEL REQUIREMENTS
1. Place glass frame assembly top over tabs at top of firebox.
2. Pull bottom handles out and up to secure assembly bottom.
3. Reinstall component upper heat shield, secure with wing nuts,
re-attach component board magnet to upper heat shield.
4. Reinstall valve access cover, using screws previously removed.
REMOVE GLASS FRAME ASSEMBLY
1. Open valve access cover by lifting front up, rotating towards glass
frame.
2. Using a phillips head screwdriver, remove screws securing valve
access cover (1 ea. side).
3. Loosen, but do not remove (2) wing nuts securing component upper
heat shield. Pull component board forward (secured to hear shield
with magnet) Remove heat shield.
4. Locate (2) spring loaded handles at bottom of firebox. Pull handles
out and down to release.
5. Lift glass frame assembly up and off (2) tabs at top of firebox.
INSTALL GLASS FRAME ASSEMBLY
Figure 13b
Figure 13a
WARNING
Non-combustible zone: No combustible materials allowed on top of fireplace within shaded area for entire width and depth
of fireplace with the exception of the header.
WARNING
DO NOT OPERATE THIS FIREPLACE WITH THE GLASS FRONT REMOVED, CRACKED OR BROKEN.
REPLACEMENT OF THE GLASS SHOULD BE DONE BY A LICENSED OR QUALIFIED SERVICE PERSON.
Screws securing valve access cover (1 ea. side)
Wing nuts securing component upper heat shield
