kozy heat CAR-39, Инструкция по установке и эксплуатации

Страница: 57 / 64

SECTION 12 TROUBLESHOOTING
#CAR-39
R.11 February 2022
57
HUSSONG MFG. CO., INC. KOZY HEAT FIREPLACES
Issue Cause Solution
Main burner flame will not
light
ON/OFF rocker switch in ON
position
Switch rocker switch to OFF position.
Gas supply turned off Check for multiple shut-offs in the supply line. Verify gas supply is turned
on.
Low gas supply Consult with plumber or gas supplier.
Check propane tank. Refill if necessary.
Wiring disconnection or improper
wiring
Check for faulty or incorrect wiring. Refer to section
9.0, ELECTRICAL
INFORMATION on page 46.
Plugged main burner orifice Remove blockage.
Pilot flame Verify the pilot flame is properly directed to ignite burner. See pilot
flame troubleshooting in this section.
Remote control not working
properly
Replace batteries.
No call for heat
Verify remote control is powered ON and thermostat operation is turned
OFF.
Pilot and burner extinguish
while in operation
No propane in tank Check propane tank. Refill if necessary.
Incorrect glass assembly
installation
Refer to section 8.1, GLASS FRAME ASSEMBLY on page 43.
Incorrect vent cap installation Adjust if necessary.
Vent cap blockage Remove debris if necessary.
Improper pitch on horizontal
venting
1/4” (6mm) rise for every 12” (305mm) of travel is required on horizontal
venting
Exhaust vent pipe leaking exhaust
gases back into firebox
Check for leaks and repair if necessary.
Excessive draft A restrictor may need to be installed or modified. Refer to section
11.2.2,
VENT RESTRICTION (AFTER INSTALLATION) on page 55.
Soot appears on glass Improper log placement Refer to section 8.4, #C39-50B LOG SET INSTALLATION on page 44.
Improper venturi setting Venturi air shutter may need to be opened slightly to allow more air into
the gas mix. Refer to section 11.2.1, BURNER VENTURI on page 54.
Incorrect vent cap installation Adjust if necessary.
Vent cap blockage Remove debris if necessary.