#BAY-41-G R.9 Sept 2018
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FACING AND FINISHING
21
4.5.3 Overlap Fit - Hanging Installation with
Adjustable Louvers (Closed Brackets)
Models #B41-PSF2 and #B41-FRSF2
The listed safety barriers are equipped with the louver built into the
safety screen face. The hanging brackets located on the back of screen
front are equipped with notches to allow the louver to be adjusted to
accommodate facing material thickness. The safety barrier is shipped
with the louver in the first notch position.
To adjust louver position:
1. Locate the (3) screws on each hanging bracket at the back of the
screen front.
2. Loosen (6) screws on both hanging brackets. This will allow you
to bend the bracket outward to adjust the louver to the desired
position.
NOTE: The position of the louver should match with the desired
position of the notched tabs needed for your installation. The louver
in the first notch position will match with the first notch position in
the notched tabs, the louver in the second notch position will match
the second notch in the notched tabs, etc.
3. Adjust the louver to the desired notch in order to accommodate
facing material and to cover the control compartment as you see
fit. Re-tighten screws on hanging brackets.
4. Install safety barrier. Center the screen front over the glass frame
assembly, allowing the hanging brackets to fit inside the air
openings.
5. Align the notched tabs with the slots in the fireplace. Raise
slightly and push back to desired position.
6. Lower the screen front until the notched tabs are firmly in
position. Verify the depth accommodates finish material, and the
notched tabs position matches the louver notch position.
7. To remove safety screen: lift the screen up and out of slots.
FIRST POSITION LOUVER NOTCH
FIRST POSITION
NOTCHED TAB
LOUVER
Figure 4.9, Safety Screen Louver and Notch Locations
NOTCHED TABS
(3) SCREWS SECURING
HANGING BRACKET
Figure 4.10, Screw Location on Hanging Bracket
Figure 4.11, Adjust Louver
