12
FRAMING
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#BAY-41-MV R.1 July 2021
3.3 Stand-off Assembly and Installation
Top stand-off brackets must be formed and attached prior to
positioning fireplace into rough opening.
NOTE: If installing a trim kit assembly, #B41-FTK, please refer Section
4.2 Finishing Trim Kit Assembly #B41-FTK on page 24 before
installing stand-offs.
NOTE: If installing exterior trim kit assembly supplied with and for use
only with safety barrier #B41-RSF2, refer to Section 4.3 Exterior Trim Kit
Assembly on page 25 before installing stand-offs.
1. Remove and save (4) screws securing stand-off heat shields and
stand-off brackets on top of the fireplace.
2. Form each top stand-off bracket by bending at perforations, as
shown.
3. Align the holes in the formed top stand-offs with the holes in
the fireplace top. Secure with the (4) screws previously removed
along with (4) screws located on top of the fireplace.
4. Form stand-off heat shields as shown. The flange will face up and
to the back of the fireplace.
5. Align the holes in the stand-off heat shields with the holes in the
top stand-off brackets. Secure with (8) screws provided in the
fireplace components packet.
BEND AT
PERFORATIONS
FORMED
STAND-OFF
Figure 3.1, Stand-Off Assembly and Installation
STAND-OFF BRACKETS AS SHIPPED
TOP STAND-OFF BRACKETS INSTALLED
STAND-OFF BRACKETS INSTALLED