24
FACING AND FINISHING
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
#BAY-41-MV R.1 July 2021
4.2 Finishing Trim Kit Assembly #B41-FTK
IMPORTANT: This trim kit assembly must be attached before fireplace
installation.
NOTE: The top trim panel must be installed with the top stand off
brackets.
1. Remove and save (5) screws securing the front sections of the
side heat shields on each side.
2. Remove nailing flanges from the sides of the unit.
3. Remove and save the top and bottom screw on each side of the
outer shell of the unit.
4. Install the side trim panels. Align the holes in the side panels
with the holes in the side of the unit as shown below. Secure
with screws previously removed from the heat shields and
nailing flanges.
5. If installed, remove the top stand-offs.
6. Install the top trim panel. Align the holes in the top trim panel
with the front holes in the stand-offs and attach to fireplace top.
Secure with previously removed screws .
7. If installed, remove and discard the existing bottom front frame
portion.
8. Install the bottom trim panel into the slots in the bottom corners
of the unit, as shown below.
Figure 4.5, Finishing Trim Kit Installation #B41-FTK
