#BAY-41-MV R.1 July 2021
Hussong Mfg. Co., Inc. • Kozy Heat Fireplaces
FACING AND FINISHING
25
4.3 Exterior Trim Kit Assembly
IMPORTANT: This exterior trim kit is supplied with and for use only with
safety barrier #B41-RSF2.
IMPORTANT: Exterior trim kit assembly must be attached before
fireplace installation.
NOTE: The top trim panel must be installed with the top stand off
brackets.
1. Remove and save (5) screws securing the front sections of the
side heat shields on each side.
2. Remove nailing flanges from the sides of the unit.
3. Remove and save the top and bottom screw on each side of the
outer shell of the unit.
4. Install the exterior trim side panels. Align the holes in the side
panels with the holes in the side of the unit as shown below.
Secure with screws previously removed from the heat shields
and nailing flanges.
5. If installed, remove the top stand-offs.
6. Install the exterior trim top panel. Align the holes in the top
trim panel with the front holes in the stand-offs and attach to
fireplace top. Secure with previously removed screws .
7. If installed, remove and discard the existing bottom front frame
portion.
8. Install the exterior trim bottom panel into the slots in the bottom
corners of the unit.
Figure 4.6, Exterior Trim Kit Installation #B41-081
