17
Quick Start
Turning the power on/off
Before you turn on the power, make sure that the
desired connections have been made as described
in “Connections” (
☞
p.12).
1. Turning the power on
1
Press KARMA Music Workstation’S [POWER]
switch to turn on the power.
The LCD screen will display the name of your
model, and the software version.
(The following graphic shows the factory-set LCD
screen . The version number is subject to change
without notice.)
2
Turn on your powered monitors or stereo amp.
3
Raise this instrument’s [VOLUME] slider to an
appropriate level, and adjust the volume of your
powered monitors or stereo amp.
2. Turning the power off
1
Set this instrument’s [VOLUME] slider and the vol-
ume of your powered monitor or stereo amp to zero.
2
Turn off the power of your powered monitor or
stereo amp.
3
Press this instrument’s [POWER] switch to turn off
the power.
Never turn off the power while data is being writ-
ten into internal memory.
If the power is turned off while processing is being
performed, memory write operations will not be com-
pleted correctly. If this occurs, this instrument will
automatically initialize its internal memory so that it
will operate correctly. This is not a malfunction.
While data is being written, the LCD screen will
indicate “Now writing into internal memory.”
Data is written into internal memory by the follow-
ing operations.
• Writing (updating) a Program, Combination,
Global Setting, or Drum Kit
• Loading Program, Combination, Global
Setting, or Drum Kit data in Disk mode
• Receiving a MIDI data dump for Program,
Combination, Global Setting, or Drum Kit data
The mode and page that will be selected when the
power is turned on
The state of this instrument when the power is turned
on will depend on the setting of “
Power On Mode
”
(GLOBAL 1.1: System, Preference page).
If “
Power On Mode
” is
Reset
(factory setting), this
instrument will automatically selects the Combination
mode 1.1: Play.
If “
Power On Mode
” is
Memorize
, this instrument will
be in the mode and page that were last selected when
the power was turned off.
The
Memorize
setting will remember the mode and
page that were last selected, the combination number
that was last selected in Combination mode, and the
program number that was last selected in Program
mode. If another mode is selected when the power is
turned on, you can press the [COMBI] key or [PROG]
key to select the 1.1: Play page with the last-selected
combination number or program number.
The LCD screen when separately sold options are
installed (When the power on)
This instrument allows you to install separately sold
options.
When the power is turned on, the type of installed
options will be displayed. After installing an option, be
sure to check this display to verify that the option was
installed correctly. If the option is not displayed here
even though it was installed, it was not installed cor-
rectly. Turn off the power and re-install the option.
(
☞
For details on installing an option, refer to PG p.264)
OPTIONS
EXB-PCM Slot1 (****):
EXB-PCM Slot2 (****):
A PCM expansion board is installed in EXB-PCM series
slot 1, 2. The type of board is shown in parentheses.
EXB-MOSS:
The EXB-MOSS option is installed.
Содержание Karma
Страница 1: ...3 E ...
Страница 42: ...36 ...
