58
4.6.3 DSCP-Queue
Mapping
This page is to change DSCP values to Physical Queue mapping table. Since the switch
fabric of JetNet only supports 4 physical queues, Lowest, Low, Middle and High. Users
should therefore assign how to map DSCP value to the level of the physical queue. In
JetNet, users can freely change the mapping table to follow the upper layer 3 switch or
routers’ DSCP setting.
After configuration, press
Apply
to enable the settings.
4.6.4 CLI Commands of the Traffic Prioritization
Command Lines of the Traffic Prioritization configuration
Feature
Command Line
QoS Setting
Queue Scheduling –
Strict Priority
JetNet 5008G-P(config)# qos queue-sched
sp Strict Priority
wrr Weighted Round Robin (Use an 8,4,2,1 weight)
JetNet 5008G-P(config)# qos queue-sched sp
<cr>
Queue Scheduling -
WRR
JetNet 5008G-P(config)# qos queue-sched wrr
Port Setting – CoS
(Default Port Priority)
JetNet 5008G-P(config)# interface
fa1
JetNet 5008G-P(config-if)# qos cos
DEFAULT-COS Assign an priority (7 highest)
JetNet 5008G-P(config-if)# qos cos 7
The default port CoS value is set 7 ok.
Note: When change the port setting, you should Select the
specific port first. Ex: fa1 means fast Ethernet port 1.
