23
Setting the duty cycle (switch-off delay)
Carefully open the front cap, set the sliding switch
7
to the
AUTO position.
► Set the desired duty cycle
9
:
Five time settings are possible: approx. 20 sec. /
approx. 1 min / approx. 5 min / approx. 15 min /
approx. 30 min.
► Pulse output
9
:
Set up the controller , meaning the output is in pulse
mode (e.g. for the activation of a staircase relay) ON:
approx. 1 second / OFF: approx. 9 seconds.
The listed duty cycles are approximate values and are subject
to technical deviations.
Fine sensitivity settings
Carefully open the front cap.
Set the sliding switch
7
to the AUTO position.
Fine adjustment of the range detection
with the
“METER” adjustment screw between the positions “-” and
“+”.
“-” smallest possible detection range
“+” largest possible detection range
Function test
The function test serves to test the motion sensor for proper
detection function in the desired installation location. In or-
der to perform the function test, set the arrow
9
to the “test”
position. To do this, make the following settings:
Set the sliding switch
7
to AUTO.
Turn the METER adjustment screw
to the „“+” position.
Turn the TIME adjustment screw
9
to the “test” position.
The twilight detection is deactivated.
Correctly install the motion sensor and connect it to the
mains voltage
4 5
.
Begin the function test
from outside of the probable
detection range and pass through the detection range trans-
versally until the motion sensor switches.
The LED
and the connected consumer switch for 2 seconds.
Adjust the “METER” adjustment screw
until the desired
detection range is set.
Repeat the function test
until a satisfactory result is
achieved.
LED
13
12
Start
End
GB
