9
Major Component Replacements
KNA4C_P32R
K2NA4C_P32R
K2NA4C_P32R5
Part
Part Number
Part Number
Part Number
Compressor
0665-101
0665-107
0665-110
Compressor Capacitor
N/A
0452-51
0452-51
Condenser Blower Motor
0261-102
0261-84
0261-84
Condenser Blower Motor Capacitor
0452-05
0452-05
0452-05
Condenser Blower Assembly
5940-01-02
5940-02-02
5940-02-02
Evaporator Blower Motor
0261-120
0261-121
0261-121
Evaporator Blower Motor Capacitor
0452-03
0452-03
0452-03
Evaporator Blower Assembly
604532-00-25
604532-00-55
604532-00-55
Filter (1 each)
650F & 8751F
650F & 8751F
650F & 8751F
Standard Features
CFC-Free Refrigerant
Internal Corrosion Protection
Low Temperature Control Thermostat
M/TAB Mounting System (modified)
NEMA 4/4X Rating Maintained (UL50)
Stainless Steel (304-2B) Cabinet
UL /CUL Recognized
Filter Removal and Service
All NEMA 4 Air Conditioners are equipped with bottom filters. P32 Series units are equipped with
an additional rear filter.
1. To replace the bottom filter simply push the filter toward the front using the rear filter
attached tab. Push the filter toward the front and downward until the rear part of the filter
clears the rear filter retainer.
2. To replace the rear filter in the P32 series lift the filter using both sides of the lower filter
frame with both hands. Push the filter toward you and upward until the bottom of the filter
clears the lower filter retainer.
3. After removal, the filters should be flushed under warm running water with the clean side
up, driving contaminants out the dirty side of the filter. If the accumulated dirt is oily,
washing in a detergent bath is recommended, followed by a warm water rinse as above.
4. The filters may be sprayed with Kooltronic A-16 Filter Recoating Adhesive to trap fine
airborne contaminants, or they may simply be dried and reinstalled as strainer type filters.
Recoating is recommended for best results.
5. Reinstall the bottom filter:
a) keeping the tab at the rear (bottom) slide filter into the front retainer,
b) press filter upward and
c) slide back into rear retainer
6. Reinstall the rear filter:
a) keeping filter at the frame sides slide it in the space between the outer rear/top
cover and internal rear panel from the bottom toward the top,
b) reaching the upper retainer, slide filter into upper retainer,
c) press filter against the unit and
d) slide down into lower retainer
NOTE: Part Numbers shown are for 60Hz/1Ø. For 50Hz consult Kooltronic.
