110013961AA
date of change: 18.08.2008
page: 11/19
7
77
7
Configuration of the parameters with “FR 4
Configuration of the parameters with “FR 4
Configuration of the parameters with “FR 4
Configuration of the parameters with “FR 4 ccccopy
opy
opy
opy----kkkkey”
ey”
ey”
ey”
FR4 copy-key: Konvekta part no. H11-001-396-C
The unit has a plug socket. Via this plug socket the operating parameters are transmitted from and to the
unit. For this the FR4 copy-key with 5-pole plug is used. The FR4 copy-key is used for factory programming
of units that should have the same parameter configuration, or for a backup of the programming of a unit
so that this can be reconstructed quickly if required.
For transmission of a configuration from a FR4 to the FR4 copy-key (UPLOAD), please proceed as follows:
1) Adjust both dip switches of the FR4 copy-key to OFF.
2) Connect the FR4 copy-key with the FR4; use the designated plug.
3) Make sure that the FR4 copy-key is connected with current supply.
4) Check the LED signal of the FR4 copy-key: In case of green LED, a configuration has already been
loaded; in case of green blinking or red blinking LED there is no valid configuration.
5) Press button on FR4 copy-key.
6) Check the LED signal: After pressing the button, the LED will be red and after successful data transmis-
sion the LED will be green.
7) Now FR4 copy-key can be plugged-off.
If this configuration which has been loaded to the FR4 copy-key should now be transmitted to another FR4
unit (DOWNLOAD), please proceed as follows:
1) Adjust both dip switches of the FR4 copy-key to ON.
2) Connect the FR4 copy-key with the FR4 that should be programmed; use the designated plug.
3) Make sure that the FR4 copy-key is connected with current supply.
4) Check the LED signal of the FR4 copy-key: The LED should be green; if LED is blinking green or red, no
valid configuration has been loaded and it doesn’t make sense to go on.
5) In case of green LED press button on FR4 copy-key.
6) Check the LED signal: After pressing the button, the LED will be red and after successful data transmis-
sion the LED will be green.
7) Now FR4 copy-key can be plugged-off.
SUPPLY ADAPTER
12 VDC
AC SUPPLY
