Kontron SBC-845D-VEA, Руководство пользователя

Страница: 112 / 131

POST Messages 4-41 SBC-845D-VEA Single Board Computer User’s Guide
BI
OS
S
etup
ä
ä ä
ä
ERROR INITIALIZING HARD DISK CONTROLLER
Cannot initialize controller. Make sure the cord is correctly and firmly installed in the bus. Be
sure the correct hard drive type is selected in Setup. Also check to see if any jumper needs to be
set correctly on the hard drive.
ä ä ä ä
FLOPPY DISK CNTRLR ERROR OR NO CNTRLR PRESENT
Cannot find or initialize the floppy drive controller. make sure the controller is installed correctly
and firmly. If there are no floppy drives installed, be sure the Diskette Drive selection in Setup is
set to NONE.
ä
ä ä
ä
Invalid EISA Configuration
PLEASE RUN EISA CONFIGURATION UTILITY
The non-volatile memory containing EISA configuration information was programmed incorrectly
or has become corrupt. Re-run EISA configuration utility to correctly program the memory.
NOTE: When this error appears, the system will boot in ISA mode, which allows you to run the
EISA Configuration Utility.
ä ä ä ä
KEYBOARD ERROR OR NO KEYBOARD PRESENT
Cannot initialize the keyboard. Make sure the keyboard is attached correctly and no keys are
being pressed during the boot.
If you are purposely configuring the system without a keyboard, set the error halt condition in
Setup to HALT ON ALL, BUT KEYBOARD. This will cause the BIOS to ignore the missing keyboard
and continue the boot.
ä ä ä ä
Memory Address Error at ...
Indicates a memory address error at a specific location. You can use this location along with the
memory map for your system to find and replace the bad memory chips.
ä ä ä ä
Memory parity Error at ...
Indicates a memory parity error at a specific location. You can use this location along with the
memory map for your system to find and replace the bad memory chips.