KBox F-300-V1K - User Guide, Rev. 1.0
// 40
To mount the KBox F-300-V1K please proceed according to the steps described:
1.
Prepare the mounting surface with sufficient screws (four screws for VESA mount) and if necessary anchors
corresponding to the mounting surface type if no VESA-compliant screw holes are available. (The recommended
screw size is M4 x 6 ~ 10 mm but it still depends on the available screw holes of the mounting surface and never
be larger than M4 if any.)
2.
Secure the base mounting bracket to the mounting surface with screws (Figure 13).
Figure 13: Securing the base mounting bracket
3.
Secure the hooked mounting bracket onto the bottom side of the KBox F-300-V1K (Figure 14) with M3 screws (6
mm long) via the VESA 75 mounting holesvia the VESA 75 mounting holes. The orientation depends on applications.
The below illustration shows the case when both I/O panels are placed rightward and leftward respectively.
Figure 14: Securing the hooked mounting bracket onto the KBox F-300-V1K
4.
Place the KBox F-300-V1K onto the mounting surface by sliding the hooked mounting bracket into the based
mounting bracket (Figure 15).
5.
Secure the hand-screw knob located on the hooked mounting bracket to fix two brackets (Figure 15).
Figure 15: Securing the KBox F-300-V1K onto the mounting surface
