KBox F-300-V1K - User Guide, Rev. 1.0
// 34
11.
Lift the bottom access cover up.
12.
Now you have access to the internal M.2 Key M socket in order to remove or install the hardware component.
13.
For closing replace carefully the bottom access cover to the system and screw it on with the retained screws.
14.
Tighten the retained screws when the cover is firmly in place.
When used as intended, the KBox F-300-V1K is to operate only in closed condition.
Only when the access covers are properly fixed with the screws and the front side with
WLAN and / or WWAN antenna(s) are properly installed and secured with the screws, it
is ensured that the user does not have access to the internal parts of the KBox F-300-
V1K.
5.1.1.
Installing SO-DIMM Memory Module(s)
To install memory module(s) please proceed according to the steps described:
1.
Open the device as described in the subsection 5.1 "Opening and Closing the Chassis" (step 1-6).
2.
Locate the SO-DIMM memory sockets (DIMM1 & DIMM2) (Figure 5, pos. 1).
3.
Align the notch on the SO-DIMM memory module with the notch in the SO-DIMM memory socket.
4.
Insert the SO-DIMM memory module into the corresponding socket at a 30-degree angle.
5.
Rotate the SO-DIMM memory module down until it snaps into place and the levers close.
Visually check that each lever latch is fully closed and correctly engaged with the notch
on the memory module edge.
6.
Repeat step 2 - 5 to install the second SO-DIMM memory module in case two DIMM memory modules are required.
Use memory modules with the same memory density in both socket!
In case only one memory module is installed, we suggest installing it on the socket
DIMM1.
7.
In order to close the device, proceed step 7 - 8 described in the subsection 5.1 "Opening and Closing the Chassis".
5.1.2.
Installing A HDD / SSD
To install a 2.5" HDD / SSD please proceed according to the steps described:
1.
Open the device as described in the subsection 5.1 "Opening and Closing the Chassis" (step 1-6).
2.
Align one side of the HDD / SSD’s screw holes with the fixing pins (Figure 6, pos. 2) of the hard disk bracket and
slide in.
3.
Align the other side of the HDD / SSD’s screw holes with the screw holes (Figure 6, pos. 3) of the hard disk bracket
and then screw the HDD / SSD to the bracket.
4.
Connect the SATA power / data cable connector (Figure 5, pos. 2) to the HDD / SSD.
5.
In order to close the device, proceed step 7 - 8 described in the subsection 5.1 "Opening and Closing the Chassis".
5.1.3.
Installing An mPCIe Expansion Card
To install an mPCIe expansion card please proceed according to the steps described:
