KBox B-201-CFL - User Guide, Rev. 1.0
// 31
6.2.1.
Installing and Removing Externally Accessible 2.5” SSD
To install a 2.5” SSD, perform the following:
1.
Open the SDD drive bay cover by following the instructions in Chapter 6.2: Opening and Closing SSD Drive
Bay Cover (steps 1 to 6).
2.
Position the 2.5” SSD on the ESD strip (Figure 14) in the SSD drive bay with the SSD’s connector facing the
internal SATA connector.
Figure 14: SSD Drive Bay with SSD
3.
Align the SSD’s connector with the internal SATA connector.
4.
Press down on the SSD and gently push the SSD into the SATA connector.
5.
Close the SSD drive bay cover as described Chapter 6.2: Opening and Closing SSD Drive Bay Cover (step 7).
After installing or removing a 2.5” SSD, the partitioning of the memory maybe different.
To remove a 2.5” SSD, perform the following:
1.
Open the SSD drive bay cover by follow the instructions in Chapter 6.2: Opening and Closing SSD Drive Bay
Cover (steps 1 to 6).
2.
Hold the sides of the SSD and pull out the SDD from the internal SATA connector carefully.
3.
If the SSD does not release easily, move the SDD slightly from side to side while gently pulling out the SSD
from the SATA connector.
4.
To install a new SDD, proceed as described Chapter 6.2.1: Installing and Removing Externally Accessible 2.5”
SSD (steps 2 to 4).
5.
Close the SSD drive bay cover as described in Chapter 6.2:.Opening and Closing SSD Drive Bay Cover (step 7).
After installing or removing a 2.5” SSD, the partitioning of the memory maybe different.
ESD strip
Содержание KBox B-201-CFL
Страница 1: ... USER GUIDE www kontron com 1 KBox B 201 CFL Doc User Guide Rev 1 0 Doc ID 1065 0689 ...
Страница 2: ...KBox B 201 CFL User Guide Rev 1 0 www kontron com 2 This page has been intentionally left blank ...
Страница 49: ...KBox B 201 CFL User Guide Rev 1 0 www kontron com 49 Figure 37 KBox B 201 CFL Value Block Diagram ...