KBox B-201-CFL - User Guide, Rev. 1.0
// 14
Additional safety instructions for DC power supply circuits
To guarantee safe operation of product s with DC power supply voltages larger than 60 volts DC or a power
consumption larger than 120 VA, please observe that:
The product is set up, installed and operated in a room or enclosure marked with “RESTRICTED ACCESS”, if
there are no safety messages such as safety signs and labels on the product itself.
No cables or parts without insulation in electrical circuits with dangerous voltage or power should be
touched directly or indirectly
A reliable protective earth connection is provided
A suitable, easily accessible disconnecting device is used in the application (e.g. overcurrent protective
device), if the product itself is not disconnectable
A disconnect device, if provided in or as part of the equipment, shall disconnect both poles simultaneously
Interconnecting power circuits of different products cause no electrical hazards
A sufficient dimensioning of the power cable wires must be selected – according to the maximum electrical
specifications on the product label – as stipulated by EN60950-1 or VDE0100 or EN60204 or UL508 regulations.
The products does not generally fulfill the requirements for "centralized DC power systems“ (UL 60950-1, Annex
NAB; D2) and therefore may not be connected to such devices!
1.1.
Electrostatic Discharge (ESD)
A sudden discharge of electrostatic electricity can destroy static-sensitive devices or micro-
circuitry.
Proper packaging and grounding techniques are necessary precautions to prevent damage. Always take the following
precautions:
1.
Transport boards in ESD-safe containers such as boxes or bags.
2.
Keep electrostatic sensitive parts in their containers until they arrive at the ESD-safe workplace.
3.
Always be properly grounded when touching a sensitive board, component, or assembly.
4.
Store electrostatic-sensitive boards in protective packaging or on antistatic mats.
1.1.1.
Grounding Methods
By adhering to the guidelines below, electrostatic damage to the product can be avoided:
1.
Cover workstations with approved antistatic material. Always wear a wrist strap connected to workplace.
Always use properly grounded tools and equipment.
2.
Use antistatic mats, heel straps, or air ionizers for more protection.
3.
Always handle electrostatically sensitive components by their edge or by their casing.
4.
Avoid contact with pins, leads, or circuitry.
5.
Turn off power and input signals before inserting and removing connectors or connecting test equipment.
6.
Keep work area free of non-conductive materials such as ordinary plastic assembly aids and Styrofoam.
7.
Use only field service tools that are conductive, such as cutters, screwdrivers, and vacuum cleaners.
8.
Always place drives and boards PCB-assembly-side down on the foam.
Содержание KBox B-201-CFL
Страница 1: ... USER GUIDE www kontron com 1 KBox B 201 CFL Doc User Guide Rev 1 0 Doc ID 1065 0689 ...
Страница 2: ...KBox B 201 CFL User Guide Rev 1 0 www kontron com 2 This page has been intentionally left blank ...
Страница 49: ...KBox B 201 CFL User Guide Rev 1 0 www kontron com 49 Figure 37 KBox B 201 CFL Value Block Diagram ...