Kontron CP6930-RM, Руководство пользователя

Страница: 31 / 50

Installation
16 CP6930-RM User Guide
www.kontron.com
2.8 Software Installation
The CP6930 board comes as a pre-installed system with all necessary OS, filesystem, drivers and applications
factory-installed with default configurations.
Updating the Software with new operating system or applications or new versions is provided by a dedicated
update mechanism, which is described in the CP6930 User Guide.
2.9 Quick Start
This section gives instructions for (initially) accessing the CLI (Command Line Interface) of the CP6930
using either in-band access via the ethernet fabric or the out-of-band management interfaces (serial port or
Fast Ethernet) accessible from the front plate serial connector or via an appropriate RIO module. The CLI is
required for configuring the GbE switch.
2.9.1 Out-of-Band CLI Access
The CLI can be accessed via serial port (using the front plate connector and provided adapter or an appropri-
ate RIO module) or Fast Ethernet (via the front plate RJ45 connector).
2.9.1.1 Serial Port
The serial port is ready to use offhand without further configuration.
Port settings are:
• 115200 bps (serial speed might be different for customized board variants)
• 8 bit, no parity, 1 stop bit (8N1)
• no flow control
2.9.1.2 Fast Ethernet Serviceport
The Gigabit Ethernet serviceport on the CP6930 front plate has no IP address set by default, it is necessary to
assign an IP address statically or enable dhcp on the serviceport. Because the required configuration steps
are done in the CLI, an initial access using the serial port is required.
The procedure for assigning an IP address to the serviceport is described in the following. User input is
printed in bold letters.
1. Connect to serial port on the front plate (using the Kontron DB9 adapter cable) or RIO module (using a
RJ45 straight cable).
2. Ensure that the board is powered up.
3. Log in as
admin
and enter privileged mode by typing ’
enable
’ (no passwords required by default).
User: admin
Password:
(Ethernet Fabric) >
enable
Password:
(Ethernet Fabric) #