Kontron AL i.MX6 ULL, Руководство пользователя

Страница: 8 / 40

AL i.MX6 ULL - Rev. 1.0
www.kontron-electronics.de
// 8
General Safety Instructions for IT Equipment
Please read this chapter carefully and take careful note of the instructions that have been compiled for
your safety and to ensure to apply in accordance with intended regulations. If the following general
safety instructions are not observed, it could lead to injuries to the operator and/or damage of the
product; in cases of non-observance of the instructions Kontron Electronics is exempt from accident
liability, this also applies during the warranty period.
The product has been built and tested according to the basic safety requirements for low voltage (LVD) applications and has left
the manufacturer in safety-related, flawless condition. To maintain this condition and to ensure safe operation, the operator must
not only observe the correct operating conditions for the product but also the following general safety instructions:

The product must be used as specified in the product documentation, in which the instructions for safety for the product and
for the operator are described. These contain guidelines for setting up, installation and assembly, maintenance, transport and
storage.

The on-site electrical installation must meet the requirements of the country's specific local regulations.

If a power cable comes with the product, only this cable should be used. Do not use an extension cable to connect the product.

To guarantee that enough air circulation is available to cool the product, ensure that if the product has ventilation openings
the openings are not covered or blocked. If an air filter is provided, this should be cleaned regularly. Additionally, make sure
the system is well ventilated by observing if heat-dissipating elements are covered/obstructed by objects as this can cause a
build-up of heat and stop heat from being dispersed into the ambient environment.

Do not place the system close to heat sources or damp places.

Only products or parts which fulfil the requirements of SELV circuits (Safety Extra Low Voltage) as stipulated by
IEC 60950-1 may be connected to the available interfaces.

Before opening the product, make sure that the product is disconnected from the mains. Complete disconnection is only
possible if the power cable is disconnected and removed. Ensure that there is free and easy access to enable disconnection.

If the product is opened for the insertion or removal of expansion devices (depending on the configuration of the system), this
may only be carried out by qualified persons.

If extensions are made to the product, the following must be observed:

All effective legal regulations and all technical data for the expansion devices are adhered to.

The power consumption of any expansion devices does not exceed the specified limitations.

The current consumption of the system does not exceed the value stated on the product label.

Only original accessories that have been approved by Kontron Electronics can be used.

Please note: safe operation is no longer possible when any of the following applies:

Damage is visible.

The device no longer functions.
In these cases, the device must be switched off and it must be ensured that the device can no longer be operated.