Konsberg AIS 200, Руководство по установке

Страница: 34 / 119

Kongsberg AIS 200 Installation Manual, rev. 2 Installation
Signal name
MKD
connector
Wire colour
D-sub 9-pin
(Mobile Unit)
Bus- 1 Brown 2
Bus+ 2 White 7
V System - 4 Black 1
2 4
1
5
FRONT VIEW V 5 White 6
Note!
Short circuit on the MKD connector may cause permanent damage to the AIS 200
Mobile Unit.
3.8 AIS 200 Mobile Unit
3.8.1 Mechanical installation
The Mobile Unit should be mounted in a place with proper ventilation. The unit is mounted
with four bolts, refer dimensional drawing on page 8.
Ensure that there is enough space on the rear side of the unit for installation of plugs and
cables. A minimum distance of 220 mm between the unit and the wall is required.
Make sure that unit is properly secured to the deck/bulkhead. Clamps are recommended to
secure power and data cables connected to the Mobile Unit.
3.8.2 Cable connection
The rear panel of the Mobile Unit contains connectors for GPS, VHF, external MKD, data
signals and power (+24V DC).
The connector types are as shown in the table below:
Type Connected to:
9 pins D-Sub, male MKD
TNC connector, Female GPS antenna
N-connector, Female VHF antenna
Screw terminals P1, P2 Data I/O
Screw terminals Power
24