Könner & Söhnen KS 2000i S, Руководство пользователя

Страница: 20 / 24

Unit
Action
At each start
First month
or 20 operating
hours
Every 3 months or 50 operating hours Every 6 months or 100 operating hours
Every year
or 300 operating
hours
Motor oil
Level check
Replacement
Air filter
Check / Cleaning
Replacement
Spark plug
Cleaning
Replacement
Fuel tank
Level check
Cleaning
Fuel filter
C heck ( clean out)
RECOMMENDED OILS
11
Upon oil level decrease it is necessary to add the required quantity in order to provide the correct generator
operation. It is necessary to check the oil levels according to technical maintanance schedule. Further details
can be found in the full version of the manual on our website.
Use oils designed for four-stroke cycle vehicle engines
SAE10W-30, SAE10W-40. Motor oils with other viscosity
levels, may be used only if the average air temperature
in your region does not exceed the limits of the
temperature range, specified in the table.
0 00
CC
10W-30, 10W-40
40 40 30 30 20 20 10 10 -10 -10 -20 -20
AIR FILTER TECHNICAL MAINTENANCE
12
Air filter cleaning is to be performed each 50 hours of the generator operation (every 10 hours in unusually
dusty conditions).
CLEANING THE FILTER:
CLEANING THE FILTER:
1. Open the clips on the upper cap of the air filter.
2. Remove the sponge filtering element.
3. Remove all dirt deposits inside the hollow case of the air filter.
4. Thoroughly wash the filtering element in warmsoapy water.
5. Dry the sponge filter.
6. Dry filtering element is to be moistened by motor oil and excess oil is to be squeezed out.
SPARK PLUGS TECHNICAL MAINTENANCE
13
Spark plug has to be intact, without soot deposits and to have a correct gap.
SPARK PLUG VERIFICATION: SPARK PLUG VERIFICATION:
1. Remove the cap from the spark plug.
2. Remove the spark plug by means of a corresponding spanner.
3. Examine the spark plug. If is is shattered – it is necessary to replace it.
Recommended replacement spark plugs – F7TC.
4. Measure the gap. It has to be within range 0.7-0.8 mm.
5. In case of repeated use, the spark plug has to be cleaned by means of a metal brush.
After that – set the correct gap.
DAMPER AND FLAME ARRESTER
MAINTENANCE
14
The engine and damper will get very hot after the generator has been started. Do not touch the engine or
damper with any part of your body or clothing during inspection or repair until they have cooled down.
Remove the screws and then pull the protective cover towards you. Loosen the bolts and remove the cover,
screen and flame arrester of the damper. Descale the screen and flame arrester of the damper with a wire
brush.Inspect the screen and flame arrester of the damper. Replace them if they are damaged. Replace
the flame arrester. Replace the screen and cover of the damper. Replace the cover and tighten the screws.
Match the protrusion of the flame arrester to the hole
in the pipe damper.
IMPORTANT!
konner-sohnen.com
| 19