E-3
2. Installation procedures
<Installing the working table>
(1) Turn OFF the power switch and unplug the
power cord from the power outlet.
(2) Remove the working table and all other accesso-
ries from the shipping carton and remove the
protective tape and protective materials.
(3) Remove the control panel left cover.
(Three screws)
(4) Remove the control panel right cover.
(Two screws)
(5) Remove the control panel front cover.
Note:
Pull the left side of the cover toward you and slide
it to the right to remove it.
(6) Remove the connector of the control panel front
cover.
Note:
Discard the removed cover.
(7) Remove the cover shown in the illustration.
(One screws)
Note:
Discard the removed screw and cover.
(8) Remove the right front cover. (Three screws)
Note:
Before removing the cover, be sure to check and
remember the location where the cover is installed
referring to the guide lines on the plate of the main
body.
Guide lines
