E-16
<When installing the biometric authentication
device>
(1) Remove the cap shown in the illustration from
the working table.
(2) Attach the biometric authentication device to the
working table at the position shown in the illustra-
tion.
Note:
• For details on the installation method, refer to
the installation manual of the Authentication
Unit AU-102.
• Route the extra length of the cable into the wire
saddles located underside of the working table.
<When installing the key counter mount kit>
(1) Remove the working table. (Four screws)
(2) Remove three shoulder screws that hold the
scanner right cover of the machine.
Remove one cap and one screw that holds the
scanner rear cover in place.
(3) While moving the scanner right cover in the
direction of the arrow, remove the cover.
Remove the knockout (one place), using nip-
pers.
(4) Open the right door of the machine.
(5) Remove the harness from the four wire saddles.
Wire saddle
