Konica Minolta IP-601, Инструкция по эксплуатации, Страница: 87 / 131

Print Controller INSTRUCTION MANUAL 4-19
Chapter 4 Control Panel Setup
●
Interrupt / Reserve
The Interrupt mode can be used to interrupt the current printing operation to perform
a copying job. The Interrupt mode can be selected when the engine is receiving print
data or when printing is already in progress.
Under some conditions of printing or Finisher settings, the Interrupt mode cannot be
used.
How to interrupt
1. Press the [INTERRUPT] key when the print job is in progress.
2. Place new original(s) on the platen glass or in the document feeder.
3. Press [START] key to start Interrupt Copying .
4. After copying is completed, press the [INTERRUPT] key again to enable the
engine to resume the Interrupted print job.
If the [INTERRUPT] key is pressed while receiving the job data, Interrupt
mode will become available after the receiving is complete.
If the [INTERRUPT] key is pressed while printing is in progress, Interrupt
mode will become available after the current set of print job is completed.
Even without pressing the [INTERRUPT] key again, interrupted print job
will resume automatically on the following conditions:
•
AUTORESET is being activated and when it reaches the set value
•
When Interrupt release timer which works 1 min after INTERRUPT job
is complete works.
This timer works when AUTORESET is not activated
How to use Reserve function
1. Touch the [FREE] folder to set the conditions for a copying job.
2. This copying job will be performed after the print job in progress is com-
pleted.