Konica Minolta IP-601, Инструкция по эксплуатации, Страница: 16 / 131

Print Controller INSTRUCTION MANUAL 1-7
Chapter 1 Overview
●
Memory
Most of the print controller memory is used for rasterizing images (bitmap extracting
process), font cache, form overlay or other functions. Only a small part of it is used
for system operation.
The basic memory setting of the print controller is 64 MB. The memory of the print
controller can be expanded to 512 MB maximum.
The more memory in the print controller, the more pages that can be rasterized while
waiting for the previous job to print. When Letter/A4 size paper is used, approximately
4,345 KB memory is required to print 1 bit data in 600 dpi.
In addition, the E-RDH memory in the main body printer is used for the print process,
which can be expanded to 512 MB maximum.
For printouts using such features as multiple copies, booklet mode and wait mode, all
data about the entire set of pages rasterized by the print controller (one job) must be
first stored in the E-RDH memory.
Therefore, there are occasions when attempting to produce a very large number of
pages using those features does not lead to the correct printouts.
If this occurs, installing additional E-RDH memory in the main body printer
(copier) is recommended.
Memory Overflow
Depending on the functions selected in the printer driver, occasional memory overflow
may occur if the volume of the print job is large. In this case the print job is cancelled.
e.g., Booklet, Fold &Stitch, 2 in 1, etc.
In case of frequent memory overflow, extending the memory capacity of the main
body printer (copier) is recommended.
Upgrading Memory
To obtain optimum printer performance, memory expansion is recommended.
Contact the nearest Konica service representative for details.