E-11
(9) Reinstall the connector cover that has been
removed in step (3).(One screw)
Note:
• Fit the connector cover protrusion in the portion
of the machine shown in the illustration below.
• Be careful not to pinch the harness.
<Routing of the modular cable>
a. When the ferrite core is not installed to the
supplied modular cable
(1) Insert the supplied modular cable in the modular
jack (LINE).
Note:
If the user is connected with a key telephone sys-
tem or a private branch exchange (PBX), do not
connect the modular cable to where other than an
analog line.
<Only when using the telephone line>
(2) Insert the modular cable of the telephone line to
the modular jack (TEL) of the fax kit (Line 1).
<Only when installing line 2>
(3) Insert the supplied modular cable in the modular
jack (LINE).
Note:
If the user is connected with a key telephone sys-
tem or a private branch exchange (PBX), do not
connect the modular cable to where other than an
analog line.
(4) Place the modular cable in the harness guide.
<When adding no paper feed options/desk or when
using the Desk DK-705>
(5) Pass the modular cable into the hole in the lower
portion of the rear right cover.
<When using the Paper Feed Cabinet PC-410/PC-
210/PC-110 or desk DK-510>
(5) Perform the following steps.
a) Remove the rear right cover from the paper
feed cabinet or the desk. (Two screws)
