Kongskilde VIBRO TILL 2900 Series, Инструкция по сборке

Страница: 29 / 44

29
The adjustment linkage is used to adjust the wings so they are level with the centre section when
working in the field.
To adjust the linkage, remove the clip pin and turn the adjustment casting clockwise or counter clockwise
to shorten or lengthen the linkage. This in turn will raise or lower the wing wheel arm position so the
wings will run level at the same depth as the centre section. The adjustment can be made with either a
large adjustable wrench, or 1-1/2" socket, or a 3/4" drive socket wrench handle only.
More information on the proper adjustment of these linkages is covered in the Owners Manual under
Field Settings and Adjustments.
Initially the adjustment slider can be set at 7' - 8" or (180 to 205mm). The distance is measured from
the edge of the outer housing tube to the centre of the pin.
Take care to replace the clip lock pin so the slider adjustment does not move from the set position.
7" - 8"
(180 - 205mm)