Kongskilde VIBRO TILL 2900 Series, Инструкция по сборке

Страница: 23 / 44

23
Wing Assembly
Gather the components for the wing frames and assemble using the hardware illustrated in the parts list booklet.
The wing frame sections are the same for both 10' (3m) and 13'(4m) centre machines. Please note that there
are no right or left wing frame components. Therefore if you assemble the right wing first as shown below, you
will need to flip the frames over opposite to the diagram below to assemble the left wing.
Mark the tine pattern on the wing frame tubes according to the locations given for each wing frame section in
the supplied tine layout book by hooking the tape measure on the side marked "0" and measuring across the
frame as you did for the centre section.
The frames should be placed on steel support stands during assembly and mounting of the tines, then carefully
lowered to the ground to rest on the tines for assembly of the wheel components. The assembly diagrams do
not show tines installed on the frames for easier viewing of the components. You may choose to assemble the
frames first and mount tines later, but generally you will find it is easier to mount the tines as you assemble
the frame sections.
Tines mounted near the hinge plates or in the wheel area should
be left loose until after the wheel arm assemblies and hinge
plates are installed to allow better access to the mounting bolts
with tools.