Kongsberg SIMRAD 11252236, Руководство пользователя, Страница: 20 / 32

Tillerpilots TP10/TP22/TP32
20
E04818 Issue 1.0
Wire Color
Brown +12 V DC
Blue 0 V
•
Use a suitable gauge cable for the run from the socket to the sup-
ply (see Fig 5.6 on previous page).
• Connect to the vessel’s switch panel via a 10 Amp fuse or breaker.
• Do not fit other electronic or electrical equipment to this cable, or
“tap into” the supply from a nearby cable – always wire each piece
of equipment to its own breaker in the electrical panel.
• Ensure all connections are well made. Poor contact will result in
loss of thrust from the Tillerpilot and slower speed of response.
• If in any doubt, employ a qualified engineer to install the equip-
ment.
5.3 Interfacing via SimNet
The TP22 and TP32 Tillerpilots are linked to other SimNet-
compatible equipment via the integral SimNet cable and plug in
the bulkhead socket.
All SimNet units (Instruments, Chartplotters, Radars, Auto-
pilots, etc.) use the same single cable to share data on the high
speed network. If there are no spare SimNet ports convenient, a
three-way cable joiner can be used to create an additional port
(see Fig 5.8, p. 21).
CAL
STBY
TACK
STBY
AUTO
Brown
12V DC
Blue
0V
Fig 5.7 - TP10 wiring
5.2.2 Installing the TP10
The TP10 Tillerpilot operates from a 12 V DC supply and is
connected to the supply by two wires (Fig 5.7). Although the
cable is supplied with bare ends, it is recommended that a good
quality waterproof plug and socket is fitted for maximum relia-
bility. A suitable plug and socket set is availble as an optional
accessory (part no.
SKT100 ; see section 6.4 ).
Wire to the electrical supply as follows: