Kongsberg Seapath 320, Руководство по установке, Страница: 31 / 152

Installation Manual
M300-62/rev.2 15
Connector Type Connected to
ALARM 3 pins terminal, relay External alarm system
MRU 10 pins terminal, RS-422 MRU5 or MRU5+
IMU 10 pins terminal Not in use
1PPS 6 pins terminal External equipment
ANALOG OUT 10 pins terminal User configurable
ANALOG IN 6 pins terminal Not in use
115/230VAC Power Input of 115/230VAC
Table 2 Connectors at rear of Processing Unit
Connector Type Connected to
LAN 1 RJ-45 User configurable
USB 1 USB User configurable
Table 3 Connectors at front of Processing Unit
Note
All numbering of the pins on the terminals goes from left (no. 1) to right
2.12.1 RS-422 A and B signal definition
According to the following standard the signal state definitions are:
IEC 61162-1. The idle, marking, logical 1, OFF or stop bit states are defined by a
negative voltage on line A with respect to line B. The active, spacing, logical 0, ON
or start bit states are defined by a positive voltage on line A with respect to line B. It
should be noted that the above A with respect to B levels are inverted from the
voltage input/output requirements of standard UARTs and that many line drivers and
receivers provide a logic inversion.
2.12.2 Pin layout
2.12.2.1 COM 1 and 2
Com 1 and Com 2 at the rear of the Processing Unit are 9-pin DSub male and have the
following pin layout.