●M2×24
(Frame t=1mm)
●2-5 Low Head Tapping Screw
No.02084（100pcs）
x 4
x 4
＊Reuse
＊Sold separately
x 8
●M2-15 (Frame t=2mm)
No.01127（50pcs）
＊Sold separately
4000 Series
6100 Series
2500 Series
Please remove 2 screws,
if you mount frames both sides.
Please keep screws for reuse.
M2×15
Countersunk head screw
M2×10
Countersunk head screw
＊Sold separately
x 4
●M2.6-15 (Frame t=2mm)
＊Sold separately
x 4
●M2.6-25~30 (Flame t=2mm)
＊Sold separately
x 4
●M3-10 (Frame t=2mm)
＊Sold separately
x 4
●M3-27 (Flame t=2mm)
6000 Series
Please remove 2 screws,
if you mount frames both sides.
Please keep screws for reuse.
Please remove 1 screw,
if you mount frames both sides.
Please keep screw for reuse.
M2.6×13
Countersunk head screw
M2.6×25
Countersunk head screw
Servos can be anchored to home-made frames or brackets using up to 8 screws. Refer to the table in the diagram
below for recommended screw sizes.
○6000/4000 series: (When frame thickness is 2mm)
1)Remove two screws shown in diagram below. 2) Secure upper and lower bracketing using designated screws.
○2000/3000 series: (When frame thickness is 1mm)
1) Remove screws from servo case. 2) Secure servo to frame using screws removed from case and designated screws.
※Removing the screws from the servo casing may result in the casing coming apart. Take care not to let the internal parts fall out or come
apart. ※*Screws for anchoring the servos are sold separately. Either purchase our optional screws or use commercially available screws.
※For details on screw locations, refer to the external diagrams included after page 12 in this manual. You can also download external diagrams
from our website.
Anchoring Servos
4
M3-25
(Case screw)
(Case screw)
(Case screw)
(Case screw)
