Konami RACING JAM, Руководство оператора

Страница: 29 / 71

27
5-2 PCB start-up check (self test)
When the power switch is turned ON after installation of machine, the performance of
game Printed Circuit Boards (PCB) is checked automatically and the result is
displayed on the screen. If the power is not turned ON, make sure that the main
power switch and internal power switch are both at the ON position. (See page43)
•Be sure to check the PCB (self test) before using the machine.
•If an abnormality persists or the machine does not operate properly,
immediately turn OFF the main power switch, unplug the power cord from
the receptacle and contact your nearest dealer.
Result of test
· The steering wheel and other components are automatically repositioned. The
machine then goes to the game mode and the demonstration game gets started.
If test is OK
5 Networking game machines and PCB settings
· “ BAD ” appears on the screen, and the checking is repeated.
If “OPTION SETTINGS BACKUP DATA ERROR.” and “PRESS TEST SWITCH
TO ALL FACTORY SETTINGS.” appear, press the test switch on the service
panel. (The settings made in the manual test will be back to the factory
settings.)
If “RECORD BACKUP DATA ERROR.” and “PRESS TEST SWITCH TO
RECORD DATA CLEAR.” appear, press the test switch on the service panel.
(The course record will be back to the factory setting.)
If “BOOKKEEPING BACKUP DATA ERROR.” and “PRESS TEST SWITCH TO
DATA INITIALIZE.” appear, press the test switch on the service panel. (The
bookkeeping data will be back to the factory setting.)
After the installation of the machine, or after the repair or replacement of PCB.
turn ON the power switch while pressing the test switch on the service panel
and once return the settings to the factory settings.
If an abnormal display continues or the machine does not operate normally,
immediately turn OFF the main power switch and contact your nearest dealer.
If any abnormality is detected