Komatsu PW98MR-10, Руководство по эксплуатации и техническому обслуживанию

Страница: 282 / 446

• Each time auto-deceleration switch is pressed, it
switches OFF to ON to OFF in turn.
• When auto-deceleration switch is turned OFF, the au-
to-deceleration pilot lamp goes out.
5.
When loading, lift the blade and/or outriggers and position
the machine with bucket raised and facing forwards.
6.
Before moving the machine onto the ramps, make sure
that the machine is positioned in a straight line with the
ramps and that the centerline of the machine matches that
of the trailer.
7.
Set the travel direction toward the ramps and drive slowly.
8.
Lower the work equipment as far as possible without caus-
ing interference.
9.
Engage the forward gear (F) and move slowly.
10. When the machine is positioned, stop it, put it in neutral
(N) and turn the turret 180 degrees.
11. Lower the blade and/or the outriggers.
12. Extend the bucket and arm cylinders fully, then lower the
boom slowly.
NOTICE
To prevent damage to the bucket cylinder during
transportation, put a block under the tip of the bucket
link to prevent the bucket cylinder from touching the
floor.
13. Set the lock lever to LOCK position (L).
14. Stop the engine, then remove the key from the starting
switch.
15. Close all of the doors, windows, and covers.
NOTICE
Stow the antenna, etc. For details, see “STOW ANTEN-
NA (3-210)”. Reassemble the mirrors (if equipped) so
that they are within the width of the machine.
16. Lock the lockable doors, covers, and caps.
RKA48158
RKA48490
TRANSPORTATION OPERATION
3-214
WENAM00061