2.
Place the blade control lever to left TILT position (E) to op-
erate it to the stroke end, and then keep it for 2 seconds or
more.
3.
Check the message on the control box screen.
When “Tilt cylinder” changes to “Angle cylinder” or when
the message of “Reset cylinder!” goes out, resetting of the
stroke end of tilt cylinder is completed.
REMARK
• If the resetting of the stroke end of tilt cylinder is not
completed, tilt RIGHT the blade once, and repeat step
2 again.
Move the cylinder to the stroke end at certain speed.
• If the resetting of the stroke end of tilt cylinder is not
completed after several trials of step 2, place the
blade control lever to tilt RIGHT position (F) to move
the cylinder to the stroke end of tilt RIGHT side, and
then keep as it is for 2 seconds or more.
RESET ANGLE CYLINDER STROKE END
(When message of “Cylinder Sensor Reset Request!”, “Angle cylinder” is displayed)
1.
Raise the blade and tilt it LEFT.
2.
Place angle switch (1) to angle LEFT position (G) to move
the cylinder to the stroke end, and then keep it as it is for 2
seconds or more.
3.
Check the message on the control box screen.
When the message of “Cylinder Sensor Reset Request!”
goes out, resetting of the stroke end of angle cylinder is
completed.
REMARK
• If the resetting of the stroke end of angle cylinder is
not completed, angle RIGHT the blade once, and re-
peat step 2 again.
Move the cylinder to the stroke end at certain speed.
• If the resetting of the stroke end of angle cylinder is
not completed after several trials of step 2, place an-
gle switch (1) to angle RIGHT position (H) to move the
cylinder to the stroke end of angle RIGHT side, and
then keep as it is for 2 seconds or more.
• Depending on the length of the pitch rod, resetting of
the stroke end of angle cylinder is only possible for ei-
ther angle LEFT or angle RIGHT.
METHOD FOR STOPPING ENGINE
NOTICE
The power supply of the control box is not linked with the starting switch of the machine. After finishing
the operation, press the power OFF switch of control box to turn off the control box power .
If the power supply of control box is not turned off, the batteries may be exhausted.
OPERATION
MACHINE OPERATIONS AND CONTROLS
3-19
Содержание D51EXi-24
