TOOL BOX
Store the tools in it.
Tool box is on the L.H. fender.
FIRE EXTINGUISHER
(if equipped)
A fire extinguisher is provided at the rear left part inside the op-
erator's cab.
The directions are described on the nameplate affixed to the
fire extinguisher. Just in case of emergency, carefully read and
understand them.
BATTERY DISCONNECT SWITCH
k
k
CAUTION
• When the battery disconnect switch is turned to OFF position, always remove the key from the
starting switch.
If someone turns the key to ON position carelessly, this is extremely dangerous.
• Do not operate the battery disconnect switch while the engine is running.
The large current generated by the alternator may burn the electric parts and cause a fire.
Operate the battery disconnect switch only when the engine is stopped.
NOTICE
• Keep the battery disconnect switch in ON position except the following cases.
• When the machine is stored for a long time (more than a month)
• When repairing the electrical system
• When performing the electric welding
• When handling the battery
• When replacing the fuse, etc.
• Do not turn the battery disconnect switch to OFF position while the system operating lamp is lit. If
the battery disconnect switch is turned to OFF position while the lamp is lit, the data in the control-
ler may be lost and system abnormality may occur.
• If this switch is turned to OFF position, all the electrical system is cut out and the functions of KOM-
TRAX-Plus stop. In addition, the time information of the clock and the radio tuning information may
be lost. In this case, set them again by referring to “CLOCK ADJUSTMENT” and “HANDLE RADIO”.
OPERATION
EXPLANATION OF COMPONENTS
3-113
Содержание D375A-8
