Manual EDU 2AE/TOP/MITO
Page 6
ATTENTION:
If you’re using open
-end wrenches, the unscrewing torque has to be set to MIN value in
order to bring the wrench back to the correct position.
14) PV torque:
Period of time in which the screwdriver works at maximum torque before switching to
the torque that has been set by the user. You can set time from 0.1 to 10.0 sec. To disable the function select
OFF by pressing
as many times as needed.
This function overlaps other time settings (brake time, ramp time, minimum time, maximum time) from the
motor start on.
ATTENTION: This function is useful for applications where the prevailing torque is higher than the final
torque (for example trilobal screws or locknuts).
Please use this function with utmost attention because an incorrect use can damage both the assembly
and the screwdriver.
Torques reached during the max torque time won’t activate the torque signal. “
Error pvt time
” will be
displayed and the red led will light up. You will hear two beep sounds, too.
- - - - - M E N U - - P R : 1 - - - - -
1 5 ) R o t a t i o n :
r i g h t
1 6 ) R e s e t
a u t :
O N
1 7 ) P r e s s
E S C :
O F F
15) Rotation:
You can choose between right tightening (standard screws) or left tightening (left threaded
screws). All the other functions will adapt to the selected direction of rotation.
16) Reset aut :
If ON, the control unit resets automatically after a cycle end.
If OFF, press OK every cycle end.
17) Press ESC:
If ON, the control unit will after an error signal, then press ESC to reset.
If OFF, the control unit resets automatically.
- - - - - M E N U - - P R : 1 - - - - -
1 8 ) E r r o r
l e v e r :
O N
1 9 ) D e f i x
a l l o w :
O F F
2 0 ) C a l i b r a t i o n :
O N
18) Error lever:
If ON, an error signal will occur if the lever has released before reaching the torque.
If OFF
, this function doesn’t work.
19) Defix allow:
if ON, the reverse switch on the screwdriver will work normally. If OFF, if you want the
screwdriver will work only forward.
20) Calibration:
If ON, you will see the torque value (Nm or in.lbs) on the main screen.
If OFF, the torque value
won’t
be displayed.
(To modify the calibration parameters see paragraph Torque calibration).
- - - - - M E N U - - P R : 1 - - - - -
2 1 ) C o m p e n s : +
0 . 0 0 Nm
2 2 ) U n i t :
Nm
2 3 ) T o r q
m i n :
0 . 0 0 Nm
Содержание EDU 2AE/TOP/MITO
Страница 22: ...Manual EDU 2AE TOP MITO Page 22 EXPLODED VIEW...
