25
(6)
Start
After input all the configuration, press [Trigger Key] to start measurement.
BS Point NO:
Back-sight point (start point)
number. If the line is continuously, it will
show the name of last station.
It will display the height, and distance on screen. Repeat measurement is available. Press
[OK] to confirm and measure the fore-sight point.
View
: display the last result for FS or BS point.
Back:
Return to last page.
As long as the new line measurement does
not start, the equipment will continue the
measurement in current line.
Measure the Detail/Stake-out Point
The calculation of detail point and stake-out point should according to the last back-sight
point. In BF method, the detail points and stake-out points can switch under any BS or FS
situation. However, in other methods, the detail points and stake-out points should be
measured after finishing all the BS points.
Press [INT] to open the detail points list. Press [SETOUT] for stake-out interface.
After changing a new station, please measure the back-sight staff before the detail points
and stake-out points. Otherwise, measurement for the detail points will fail. After all the
measurement in the current station, please press [OK] to confirm then save the data, press
[BACK] to cancel then re-measure this station.
The detail measurement will show the height difference between the BS to current station,
and the height difference between the last detail points to current station.
The point name will increasing in automatic after measurement in each time.
