SC200 Installation& Operation Manual
3-16
1
Safety Warnings and Information
Special attention should be given to potential hazard labeling on the equipment and the signal
words and symbols that are used throughout this manual. They may also be used to alert against
unsafe practices.
WARNING:
Indicates a potentially hazardous situation that may result in serious injury or
death.
CAUTION:
Indicates a potentially hazardous situation that may result in personal injury.
The situation may also result in equipment or property damage.
NOTE: Indicates installation, operation, or maintenance information which is important, but not
related to personal injury or property damage.
NOTE:
•
Check for freight damage before proceeding with the equipment installation. Be sure to inspect the
equipment carefully for any damage that may not have been evident on the outside of the carton.
Contact the freight carrier immediately to report any damage and file a claim. Have carrier note the
damage on the bill of lading. Call Kold-Draft with your claim number to arrange replacement or repair.
•
Read the entire manual before installing, operating or servicing the machine.
•
To ensure optimal efficiency and productivity follow these installation instructions exactly.
•
All machines have been tested and adjusted for correct performance at the factory.
•
Knowledge of proper installation and service procedures is essential for the safe operation and
maintenance of KOLD-DRAFT equipment. Refer all installation and service work to qualified
technicians.
•
This equipment must be installed in compliance with the applicable federal, state/province, and/or local
plumbing, electrical, and health/sanitation codes and requirements
.
•
Always disconnect the power supply before servicing the equipment or when the equipment will not be
used for a period of time. Some circuits remain energized when the machine is switched off.
•
Never operate equipment that has been damaged or does not have all the protective covers in place.
•
Never operate equipment that has been altered from the original KOLD-DRAFT specifications.
WARNING:
Use only genuine KOLD-DRAFT replacement parts, Use of non-approved
parts when servicing KOLD-DRAFT equipment may create a safety hazard,
cause equipment damage, property damage and will void the warranty.
